Will a 96 mm Drawer Pull Fit 3-Inch Screw Holes?

Two brass drawer pulls and a metal ruler rest on a workbench in front of an old wooden drawer with two screw holes.

A 96 mm pull won’t line up with a pair of holes spaced 3 inches apart. Three inches is 76.2 mm. The measurement that matters is the distance between screw-hole centers. A pull can extend beyond both holes and still fit.

This post contains affiliate links. As an Amazon Associate I earn from qualifying purchases.

Measure the old holes before ordering

  1. Take off one existing pull. Measure from the center of one screw hole to the center of the other. If both holes are the same diameter, you can also measure from the left edge of one to the left edge of the other.
  2. Match the center-to-center specification. Some U.S. listings round 3 inches to 76 mm. If a listing mentions both 3 inches and 96 mm, make sure the selected variant matches the drawer.
  3. Check the old outline and screw length. An old pull can leave a light mark behind. Compare the new pull’s footprint and follow its guidance for drawer-front thickness and mounting screws.

Choose the path that fits the drawer

To use the existing holes, buy the matching spacing. For example, Amerock lists its 253LB light antique brass pull with 3-inch centers. Start with one and test it on the drawer before ordering a full set. Amerock 253LB 3-inch specifications.

If you’re starting with a blank drawer or deliberately moving to a new hole pattern, a jig can keep the spacing consistent across several fronts. Kreg lists both 3-inch and 96 mm settings for its KHI-PULL Cabinet Hardware Jig. Check the spacing against the new hardware before marking the drawer. Kreg jig specifications · Kreg spacing chart.

Check the Kreg KHI-PULL jig on Amazon if you need to drill a new pattern.

The featured image illustrates how two pulls can look similar while using different hole spacing.