The ART DJPRE II makes sense when your moving-magnet turntable sends a phono-level signal and your powered speakers or amplifier only have a line-level input. If your turntable already has a LINE setting, or your receiver has a compatible PHONO input, you can usually use the phono stage you already have.
As an Amazon Associate I earn from qualifying purchases.

Do I need it for this setup?
| Your setup | Where the phono stage goes |
|---|---|
| Phono-only MM turntable and powered speakers with RCA line in | Turntable → ART DJPRE II → powered speakers. |
| Turntable with LINE output and powered speakers with line in | Use the turntable’s built-in preamp and connect directly. |
| Phono-only MM turntable and receiver with a compatible PHONO input | Connect directly to the receiver’s PHONO input. |
| Phono-only MM turntable and passive speakers | Use a phono stage and a separate speaker amplifier, or an integrated amp with an MM phono stage. |
How to connect the ART without doubling up on preamps
Run the turntable’s RCA leads to the ART input and attach the turntable’s ground wire if it has one. Run the ART’s output to an AUX or line input. If your turntable has a PHONO/LINE switch, set it to PHONO when using the ART as the phono stage. The ART converts the turntable signal to line level, so its output goes to a line input.
Play a record and use the front gain knob and signal/clip light to dial in the level. If the light repeatedly flashes red on louder passages, turn the gain down. ART also provides switchable input capacitance and a low-cut filter. Start with your cartridge manufacturer’s guidance for loading.
For the ports and controls, see ART’s DJPRE II owner’s manual. For a practical pairing, compare the Fluance RT82 connection options and the Yamaha A-S301’s built-in phono input.
